Default Settings On The Express Setup Page; Enabling The Radio Interfaces - Cisco Aironet 1130AG Hardware Installation Manual

Hide thumbs Also See for Aironet 1130AG:
Table of Contents

Advertisement

Chapter 3
Configuring the Access Point for the First Time

Default Settings on the Express Setup Page

Table 3-1
Table 3-1
Setting
System Name or Host Name
Configuration Server Protocol
IP Address
IP Subnet Mask
Default Gateway
Role in Radio Network
Web Server
SNMP Community
Optimize Radio Network for
Aironet Extensions
1.When you connect a 1130AG series access point running Cisco IOS Release 12.3(2)JA or later with a default configuration to
your LAN, the access point requests an IP address from your DHCP server and, if it does not receive an address, continues to send
requests indefinitely.

Enabling the Radio Interfaces

In Cisco IOS Release 12.3(4)JA, the access point radios are disabled by default, and there is no default
SSID. You must create an SSID and enable the radios before the access point will allow wireless
associations from other devices. These changes to the default configuration improve the security of
newly installed access points. Refer to the
for instructions on configuring the SSID.
To enable the radio interfaces, follow these instructions:
Use your internet browser to access your access point.
Step 1
When the Summary Status page displays, click Network Interfaces > Radio0-802.11g and the radio
Step 2
status page displays.
Step 3
Click Settings and the radio settings page displays.
Step 4
Click Enable in the Enable Radio field.
Step 5
Click Apply.
Click Radio1-802.11A and the radio status page displays.
Step 6
Repeat Steps 3 to 5.
Step 7
Close your internet browser.
Step 8
OL-6226-02
lists the default settings for the settings on the Express Setup page.
Default Settings on the Express Setup Page
Default
ap
DHCP
Assigned by DHCP
Assigned by DHCP
Assigned by DHCP
Access point (root)
Standard (HTTP)
defaultCommunity
Throughput
Enable
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
1
"Configuring Basic Security Settings" section on page 3-10
Assigning Basic Settings
3-9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents