Setting Up A Repeater As A Leap Client - Cisco M10-RM Software Manual

Chapter 19 Configuring Repeater and Standby Access Points and Workgroup Bridge Mode
The repeater access point should also appear as associated with the root access point in the root access
point's Association Table.

Setting Up a Repeater As a LEAP Client

You can set up a repeater access point to authenticate to your network like other wireless client devices.
After you provide a network username and password for the repeater access point, it authenticates to
your network using LEAP, Cisco's wireless authentication method, and receives and uses dynamic WEP
keys.
Setting up a repeater as a LEAP client requires three major steps:
1.
2.
3.
Command
Step 1 configure terminal
Step 2
interface dot11radio { 0 | 1 }
Step 3 ssid ssid-string
Step 4 authentication network-eap
list-name
Step 5 authentication client username
username
password password
OL-14209-01
Create an authentication username and password for the repeater on your authentication server.
Configure LEAP authentication on the root access point to which the repeater associates. The access
point to which the repeater associates is called the parent access point. See
Authentication Types," for instructions on setting up authentication.
On the repeater access point, you must enable the same cipher suite or WEP encryption
Note
method and WEP features that are enabled on the parent access point.
Configure the repeater to act as a LEAP client. Beginning in Privileged Exec mode, follow these
instructions to set up the repeater as a LEAP client:
Purpose
Enter global configuration mode.
Enter interface configuration mode for the radio interface.
The 2.4-GHz radio and the 2.4-GHz 802.11n radio is 0.
The 5-GHz radio and the 5-GHz 802.11n radio is 1.
Create an SSID and enter SSID configuration mode for the new
SSID. The SSID can consist of up to 32 alphanumeric characters,
but they should not include spaces. SSIDs are case-sensitive.
Enable LEAP authentication on the repeater so that
LEAP-enabled client devices can authenticate through the
repeater. For list-name, specify the list name you want to use for
EAP authentication. You define list names for EAP and for MAC
addresses using the aaa authentication login command. These
lists define the authentication methods activated when a user logs
in and indirectly identify the location where the authentication
information is stored.
Configure the username and password that the repeater uses when
it performs LEAP authentication. This username and password
must match the username and password that you set up for the
repeater on the authentication server.
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
Aligning Antennas
Chapter 11, "Configuring
19-7