Configuring The Ethernet Encapsulation Transformation Method - Cisco M10-RM Software Manual

Chapter 6 Configuring Radio Settings
Aironet extensions are enabled by default. Beginning in privileged EXEC mode, follow these steps to
disable Aironet extensions:
Command
Step 1 configure terminal
Step 2
interface dot11radio { 0 | 1slot/port
}
Step 3
no dot11 extension aironet
Step 4 end
Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.
Use the dot11 extension aironet command to enable Aironet extensions if they are disabled.

Configuring the Ethernet Encapsulation Transformation Method

When the wireless device receives data packets that are not 802.3 packets, the wireless device must
format the packets to 802.3 using an encapsulation transformation method. These are the two
transformation methods:
•
•
Beginning in privileged EXEC mode, follow these steps to configure the encapsulation transformation
method:
Command
Step 1 configure terminal
Step 2 interface dot11radio { 0 | 1slot/port
}
Step 3 payload-encapsulation
snap | dot1h
Step 4
end
Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.
OL-14209-01
802.1H
RFC1042—This is the default setting. Use this setting to ensure interoperability with non-Cisco
Aironet wireless equipment.
Configuring the Ethernet Encapsulation Transformation Method
Purpose
Enter global configuration mode.
Enter interface configuration mode for the radio interface. The
2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.
The 802.11n 2.4-GHz radio is radio 0
The 802.11n 5-GHz radio is radio 1.
Disable Aironet extensions.
Return to privileged EXEC mode.
Purpose
Enter global configuration mode.
Enter interface configuration mode for the radio interface. The
2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.
The 802.11n 2.4-GHz radio is radio 0
The 802.11n 5-GHz radio is radio 1.
Set the encapsulation transformation method to RFC1042
(snap) or 802.1h (dot1h, the default setting).
Return to privileged EXEC mode.
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
6-27