Monitoring And Maintaining The Dhcp Server Access Point; Show Commands - Cisco M10-RM Software Manual

Configuring the Access Point to Provide DHCP Service
Use the no form of these commands to return to default settings.
This example shows how to configure the wireless device as a DHCP server, exclude a range of IP
address, and assign a default router:
AP# configure terminal
AP(config)# ip dhcp excluded-address 172.16.1.1 172.16.1.20
AP(config)# ip dhcp pool wishbone
AP(dhcp-config)# network 172.16.1.0 255.255.255.0
AP(dhcp-config)# lease 10
AP(dhcp-config)# default-router 172.16.1.1
AP(dhcp-config)# end

Monitoring and Maintaining the DHCP Server Access Point

These sections describe commands you can use to monitor and maintain the DHCP server access point:
•
•
•

Show Commands

In Exec mode, enter the commands in
DHCP server.
Table 5-2
Command
show ip dhcp conflict [ address ]
show ip dhcp database [ url ]
show ip dhcp server statistics
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
5-24
Show Commands, page 5-24
Clear Commands, page 5-25
Debug Command, page 5-25
Show Commands for DHCP Server
Chapter 5 Administering the Access PointWireless Device Access
Table 5-2 to display information about the wireless device as
Purpose
Displays a list of all address conflicts recorded by
a specific DHCP Server. Enter the wireless
device's IP address to show conflicts recorded by
the wireless device.
Displays recent activity on the DHCP database.
Note Use this command in privileged EXEC
mode.
Displays count information about server statistics
and messages sent and received.
OL-14209-01