Cisco M10-RM Software Manual page 333

Chapter 15 Configuring QoS
Enter the maximum percentage of the channel to be used for voice in the Max Channel Capacity (%)
Step 3
field.
Step 4 Enter the maximum percentage of the channel to use for roaming calls in the Roam Channel Capacity
(%) field.
The percentage of the channel used by roaming calls up to the value specified in this field is deducted
from the value you specified in the Max Channel Capacity (%) field.
For example, suppose you have entered 75% in the Max Channel Capacity (%) field and 6% in the
Roam Channel Capacity (%). If roaming calls are using 5% of the channel, a maximum of 70% of the
channel can be used for voice.
To use video access category (AC = 2) for signaling, select the Admission Control check box under
Step 5
Video(CoS 4-5).
The admission control settings you have configured in this section will not take effect until you enable
Note
admission control on an SSID.
Enabling Admission Control
This section describes how to enable admission control on an SSID.
For a list of Cisco IOS commands for enabling admission control using the CLI, consult the Cisco IOS
Command Reference for Cisco Aironet Access Points and Bridges.
Follow these steps to enable admission control on an SSID:
Open the SSID Manager page.
Step 1
Select an SSID.
Step 2
Under General Settings, select Enable in the Call Admission Control field.
Step 3
Troubleshooting Admission Control
You can use two CLI commands to display information to help you troubleshoot admission control
problems:
•
•
•
OL-14209-01
To display current admission control settings on radio 0, enter the following command:
# show dot11 cac int dot11Radio 0
To display current admission control settings on radio 1, enter the following command:
# show dot11 cac int dot11Radio 1
To display information about admitted streams with admission control and MT, enter the following
command:
# show dot11 traffic-streams
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
Configuring QoS
15-13