Cisco M10-RM Software Manual page 147

Chapter 6 Configuring Radio Settings
If the channel selected is one of the channels in
•
for 60 seconds.
• If there are no radar signals on the new channel, enables beacons and accepts client associations.
If participating in WDS, sends a DFS notification of its new operating frequency to the active WDS
•
device.
You cannot manually select a channel for DFS-enabled 5-GHz radios in Europe and Singapore. The
Note
access points randomly selects a channel. However, in Japan, you can manually select a channel if a radar
has not been detected on it for the previous 30 minutes. If you attempt to select a channel that is
unavailable due to radar detection, the CLI displays a message stating the channel is unavailable.
The full list of channels that require DFS is shown in
Table 6-4
Channel
52
56
60
64
100
For autonomous operation, DFS requires random channel selection among the channels listed in
Table
listed in
Prior to transmitting on any channels listed in
Availability Check (CAC). The CAC is a 60 second scan for the presence of radar signals on the channel.
The following sample messages are displayed on the access point console showing the beginning and
end of the CAC scan:
*Mar 6 07:37:30.423: %DOT11-6-DFS_SCAN_START: DFS: Scanning frequency 5500 MHz for
60 seconds
*Mar 6 07:37:30.385: %DOT11-6-DFS_SCAN_COMPLETE: DFS scan complete on frequency
5500 MHz
When operating on any of the DFS channels listed in
access point constantly monitors the channel for radar. If radar is detected, the access point stops
forwarding data packets within 200 ms and broadcasts five beacons that include an 802.11h channel
switch announcement, indicating the channel number that the access point begins using. The following
example message displays on the access point console when radar is detected:
*Mar 6 12:35:09.750: %DOT11-6-DFS_TRIGGERED: DFS: triggered on frequency 5500 MHz
When radar is detected on a channel, that channel my not be used for 30 minutes. The access point
maintains a flag in non-volatile storage for each channel that it detects radar on in the last 30 minutes.
After 30 minutes, the flag is cleared for the corresponding channel. If the access point is rebooted before
a flag is cleared, the non-occupancy time is reset to 30 minutes when the channel initializes.
OL-14209-01
DFS Channel List
Frequency
5260 MHz
5280 MHz
5300 MHz
5320 MHz
5500 MHz
6-4. The user interface prevents you from manually configuring these channels. The channels not
Table 6-4 do not require random selection and may be manually configured.
Table 6-4, scans the new channel for radar signals
Table
Channel Frequency
104 5500 MHz
108 5520 MHz
112 5560 MHz
116 5580 MHz
120 5600 MHz
Table 6-4, the access point radio performs a Channel
Table
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
Configuring Radio Channel Settings
6-4.
Channel
124
128
132
136
140
6-4, in addition to performing the CAC, the
Frequency
5620 MHz
5640 MHz
5660 MHz
5680 MHz
5700 MHz
6-17