Cisco M10-RM Software Manual page 414

Working with Software Images
For more information, refer to the documentation for your FTP server.
Downloading an Image File by Using FTP
You can download a new image file and overwrite the current image or keep the current image.
Caution For the download and upload algorithms to operate properly, do not rename image directories.
Beginning in privileged EXEC mode, follow Steps 1 through 7 to download a new image from an FTP
server and overwrite the existing image. To keep the current image, skip Step 7.
Command
Step 1
Step 2
Step 3 configure terminal
Step 4 ip ftp username username
Step 5
ip ftp password password
Step 6
end
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
20-24
Chapter 20
Purpose
Verify that the FTP server is properly configured by referring
to the "Preparing to Download or Upload an Image File by
Using FTP" section on page
Log into the access point through a Telnet session.
Enter global configuration mode.
This step is required only if you override the default remote
username or password (see Steps 4, 5, and 6).
(Optional) Change the default remote username.
(Optional) Change the default password.
Return to privileged EXEC mode.
Managing Firmware and Configurations
20-23.
OL-14209-01