Configuring Mp Binding For Dcc - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Table 1-13 Configure multiple interfaces to receive calls from multiple remote ends
Configure the remote user name
Delete the remote user name
Configure the link layer protocol to PPP
Configure an authentication mode
Configure the interface to send the local
user name and password for PAP
authentication
Configure the user name that the local
end will send to the remote end for
CHAP authentication
Configure the password that the local
end will send to the remote end for
CHAP authentication
Configure the username of the remote
end that is allowed to dial in
Configure a password for the remote
end that is allowed to dial in
Note:
The users are recommended to configure either PAP or CHAP authentication on
both the physical and dialer interfaces of both sender and receiver.
When PPP is encapsulated on a Dialer interface, the remote user name gained
through PPP authentication procedure will determine the Dialer interface for
receiving calls, then the command dialer user is a must and the command dialer
number is optional.

1.2.4 Configuring MP Binding for DCC

I. Implementing MP by setting link load thresholds
In DCC applications, you can configure load thresholds for links.
When you set the link load threshold in the range 1 to 99, MP tunes allocated bandwidth
according to actual traffic percentage as follows:
When the percentage of traffic on a link to bandwidth exceeds the defined traffic
threshold, the system automatically brings up the second link, and assigns them to
one MP bundle. When the percentage of traffic on these two links to bandwidth
Operation
3Com Corporation
1-19
Chapter 1 DCC Configuration
Command
dialer user username
undo dialer user
link-protocol ppp
ppp authentication-mode { pap |
chap }
ppp pap local-user
password { cipher | simple } password
ppp chap user username
ppp chap password { cipher | simple }
password
local-user username
password { cipher | simple } password
username