3Com Router 3000 Ethernet Family
Configuration Guide
Table 3-7 Configure the answer mode for the modem
Configure the modem to work in
auto-answer mode
Configure the modem to work in
non-auto answer mode
By default, the modem works in non-auto answer mode.
3.2.6 Configuring Modem Callback
Perform the following configuration in system view.
Table 3-8 Configure modem callback
Enable modem callback
Disable modem callback
By default, modem callback is disabled.
3.3 Modem Display and Debug
Execute the debugging command in all views for the debugging.
Table 3-9 Display and debug modem
Enable modem debugging
3.4 Typical Modem Configuration Example
3.4.1 Managing Modem through Modem Script
I. Configuring a modem adaptation baud rate
1)
Network requirements
On the router, interface serial0/0/0 is connected to a modem. It uses the standard AT
command to negotiate a modem baud rate. The interface sends the AT command to the
modem. If an "OK" is received from the modem, it indicates that the modem can
automatically adapt to the corresponding baud rate. Then, write the configuration into
the modem for conservation, and the corresponding AT command is "AT&W".
Operation
Operation
Operation
3Com Corporation
3-6
Chapter 3 Modem Configuration
Command
modem auto-answer
undo modem auto-answer
Command
service modem-callback
undo service modem-callback
Command
debugging modem