3Com 3C13636 Configuration Manual page 1446

3Com Router 3000 Ethernet Family
Configuration Guide
II. Network diagram
Bri0/0/0
Bri1/0/0
Router A
Figure 1-11 Network for the DCC application providing MP binding
III. Configuration procedure
1) Configure RouterA
# Configure the dial-up ACL, local user userb, and flow control interval.
[3Com] dialer-rule 1 ip permit
[3Com] local-user userb
[3Com-luser-userb] password simple userb
[3Com-luser-userb] service-type ppp
[3Com-luser-userb] quit
[3Com] flow-interval 3
# Configure the address of interface Dialer0, enable RS-DCC and MP bundling.
[3Com] interface dialer 0
[3Com-Dialer0] ip address 100.1.1.1 255.255.255.0
[3Com-Dialer0] undo dialer enable-circular
[3Com-Dialer0] dialer user userb
[3Com-Dialer0] dialer bundle 1
[3Com-Dialer0] ppp mp
[3Com-Dialer0] dialer threshold 50
# Configure the users that are allowed to dial-up Dialer0 interface, PPP authentication
information and the DCC to the remote end.
[3Com-Dialer0] dialer-group 1
[3Com-Dialer0] ppp authentication-mode pap
[3Com-Dialer0] ppp pap local-user usera password simple usera
[3Com-Dialer0] dialer number 8810152
# Configure Bri0/0/0 PPP authentication information and the Dialer bundle to which the
interface belongs.
[3Com-Dialer0] interface bri 0/0/0
[3Com-Bri0/0/0] undo dialer enable-circular
[3Com-Bri0/0/0] dialer bundle-member 1
[3Com-Bri0/0/0] ppp mp
[3Com-Bri0/0/0] link-protocol ppp
[3Com-Bri0/0/0] ppp authentication-mode pap
[3Com-Bri0/0/0] ppp pap local-user usera password simple usera
8810148
ISDN
NT1
8810149
NT1
3Com Corporation
1-45
Chapter 1 DCC Configuration
8810152
Pri0/0/0
Router B