Setting The Parameters Of A Wred Dscp; Wred Display And Debug - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide

4.2.4 Setting the Parameters of a WRED DSCP

When an interface is configured with WRED, you can set the lower limit, upper limit,
and drop probability denominator of a WRED DSCP.
Perform the following configuration in interface view.
Table 4-4 Set the parameters of a WRED DSCP
Set the parameters of a WRED DSCP
Restore the default settings of a WRED
DSCP
Before configuring the WRED parameters, you must use the qos wred command to
apply the WRED to an interface.

4.3 WRED Display and Debug

After the above configuration, execute display command in any view to display the
running of the WRED configuration, and to verify the effect of the configuration.
Table 4-5 Display WRED configuration and statistics information on the interface
Display WRED configuration and
statistics
interface
This command can show WRED configuration and statistics information on one or all
interfaces
Operation
Operation
information on the
3Com Corporation
Chapter 4 Congestion Avoidance
qos wred dscp dscp-value low-limit
low-limit
discard-probability discard-prob
undo qos wred dscp dscp-value
Command
display qos wred interface [ interface-type
interface-number ]
4-5
Command
high-limit high-limit