3Com 3C13636 Configuration Manual page 1409

3Com Router 3000 Ethernet Family
Configuration Guide
To enable DCC to originate a call normally, the user must configure a DCC dialer ACL
and associate the corresponding interface (physical or dialer interface) to the dialer
ACL through the dialer-group command. Otherwise, DCC cannot normally originate a
call. The user can either directly configure the conditions for filtering packets in the DCC
dialer ACL, or reference the filtering rules in an ACL.
Perform the configuration of the dialer-group command in dial interface (physical or
dialer interface) and other configurations in system view.
Table 1-3 Configure physical interface mode
Configure DCC dial-up ACL
Delete DCC dial-up ACL
Configure the dialer group on
a dialer interface
Remove a dialer interface
from a specified dialer group.
Create and enter an ACL view
Configure the standard ACL
rule
Configure the extended ACL
rule
Configure the interface-based
ACL rule
By default, neither DCC dialer ACL, nor the access control group assigned with a dial
interface is configured.
Note:
Make sure that the arguments in the commands dialer rule dialer-number and
dialer-group dialer-group are consistent.
Operation
3Com Corporation
Command
dialer-rule dialer-number { protocol-name { permit
| deny } | acl acl-number }
undo dialer-rule
protocol-name }
dialer-group group-number
undo dialer-group
acl number access-list-number
rule [ rule-id ] { permit | deny } [ source sour-addr
sour-wildcard | any ] [ time-range time-name ]
[ logging ] [ fragment ]
rule [ rule-id ] { permit | deny } protocol [ source
sour-addr sour-wildcard | any ] [ destination
dest-addr dest-mask | any ] [ source-port operator
port1 [ port2 ] ] [ destination-port operator port1
[ port2 ] ] [ icmp-type icmp-type icmp-code ]
[ precedence precedence ] [ tos tos ] [ time-range
time-name ] [ logging ] [ fragment ]
rule [ rule-id ] { permit | deny } { interface type
number } [ time-range time-name ] [ logging ]
1-8
Chapter 1 DCC Configuration
dialer-number { acl |