Configuring Mpls Car - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
III. Configuring policy
Firstly you should define a policy with a certain policy name and then enter the policy
view to specify the behavior for the class defined.
Perform the following configurations in the system view.
Table 6-9 Define the policy and enter the policy view
Define the policy and enter the policy view
Delete the specified policy
Perform the following configurations in the policy view.
Table 6-10 Specify the traffic behavior for the class in the policy
Specify the traffic behavior for the class in the
policy
Remove the application of the specified class in
the policy
IV. Applying policy
Perform the following configuration in interface or ATM PVC view.
Table 6-11 Apply a policy to the interface or ATM PVC
Apply a policy to the interface or ATM
PVC
Remove the application of the policy
on the interface or ATM PVC

6.2.4 Configuring MPLS CAR

Complete these two steps to configure MPLS CAR: First, determine supervision targets
(what kinds of packets). Second, define supervision policy. You can choose access
control list (ACL) or TP list (carl-index) in the first step or just select the any keyword to
supervise all packets. For more details, refer to Traffic Supervision Configuration.
I. Applying TP policy on the interface and labeling MPLS packets
Apply TP policy (CAR) on the interface and label MPLS packets.
Operation
Operation
Operation
3Com Corporation
6-5
Command
qos policy policy-name
undo qos policy policy-name
classifier tcl-name behavior
behavior-name
undo classifier tcl-name
Command
qos apply policy policy-name { inbound |
outbound }
undo qos apply policy { inbound |
outbound }
Chapter 6 MPLS QoS
Command