Configuring Flow Check Interval; Displaying And Debugging The Backup Center - 3Com 3C13636 Configuration Manual

3Com Router 3000 Ethernet Family
Configuration Guide
Table 2-7 Set backup bandwidth of the main interface
Set backup bandwidth of the main
interface.
Restore the default backup bandwidth of
the main interface.
The number argument defaults to 0.

2.2.8 Configuring Flow Check Interval

When the main interface participates in backup load sharing, the backup center checks
its traffic size automatically at the interval configured using this command.
Before you can use this command, you must configure the standby interface
command.
Perform the following configuration in the view of the main interface.
Table 2-8 Configure the flow check interval on the main interface
Configure the interval for checking the
traffic size on the main interface.
Restore the default flow check interval.
The flow check interval defaults to 30 seconds.

2.3 Displaying and Debugging the Backup Center

After completing the above configurations, you may execute the display command in
any view to view the operating state about the backup center, and to verify the effect of
the configurations.
Execute the debugging command in user view to enable debugging and to view state
parameters for monitoring and maintenance purpose.
Table 2-9 Display and debug the backup center
Enable backup debugging.
Disable backup debugging.
Display statistics about the traffic on the main
interfaces
balancing.
Operation
Operation
Operation
participating in backup
3Com Corporation
2-5
Chapter 2 Backup Center Configurations
Command
standby bandwidth number
undo standby bandwidth
Command
standby timer flow-check interval-time
undo standby timer flow-check
Command
debugging standby event
undo debugging standby event
load display standby flow