Igmp Filter Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

IGMP Filter Configuration

To display the following form, go to the IGMP Filters Configuration form. Select a Filter ID, or open the
IGMP Filters folder and click Add Filter.
The following table describes the IGMP Filter Configuration controls:
Table 148 IGMP Filter Configuration controls
Control
Filter Identifier (1 - 16)
Enabled?
Range 1 IP Multicast Address
Range 2 IP Multicast Address
Action
Description
Selects an IGMP filter to configure.
Enables or disables this IGMP filter.
Configures the start of the range of IP multicast addresses for this filter.
Configures the end of the range of IP multicast addresses for this filter.
Allows or denies multicast traffic for the IP multicast address range specified.
Configuring the switch
218