Ip Interface Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

IP Interface Configuration

To display the following form, go to the IP Interfaces Configuration form. Select an IP Interface number, or
open the IP Interfaces folder and click Add IP Interface.
The switch can be configured with up to 250 IP interfaces. Each IP interface represents the switch on an IP
subnet on your network. The Interface option is disabled by default.
The following table describes the IP Interface Configuration controls:
IP Interface Configuration controls
Table 136
Control
IP Interface Identifier (1-250)
IP Address
Enabled?
Subnet Mask
VLAN Membership ID (1-4095)
Enable/Disable BOOTP Relay
Description
Selects an IP interface to configure.
Configures the IP address of the switch interface using dotted decimal notation.
Enables or disables this IP interface.
Configures the IP subnet address mask for the interface using dotted decimal
notation.
Configures the VLAN number for this interface. Each interface can belong to one
VLAN, although any VLAN can have multiple IP interfaces in it.
Enables or disables the BOOTP relay on this interface. The default value is
enabled.
Configuring the switch
204