Download  Print this page

Switch Setup; Configuring Ip Interfaces; Enabling Or Disabling Bbi Access; Web Browser Setup - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

Hp 10gb ethernet bl-c switch browser-based interface reference guide.
Hide thumbs

Advertisement

Switch setup

Before you can access the BBI, minimal configuration is required on the switch.

Configuring IP interfaces

At least one IP interface must be configured on the switch. This is usually done from the command line
interface during first-time switch set up. Each IP interface address provides a point of access for switch
management.
For more information about configuring an IP interface for management access, see the "Using the
command line interface" section in the "Accessing the switch" chapter of the HP 10Gb Ethernet BL-c
Switch Application Guide.

Enabling or disabling BBI access

By default, BBI access is enabled. If you need to disable or re-enable access, use the following command
from the command line interface:
>> Main# /cfg/sys/access/http <disable|enable (or just d|e)>
By default, secure BBI access is disabled. If you need to enable access, use the following command from
the command line interface:
>> Main# /cfg/sys/access/https/access <disable|enable (or just d|e)>
The default TCP port to use for BBI access is port 80. To change the port number, use the following
command:
>> Main# /cfg/sys/access/wport <TCP port number>
For more information on accessing and configuring the switch through the command line interface, see
the HP 10Gb Ethernet BL-c Switch Command Reference.

Web browser setup

Most modern Web browsers work with frames and JavaScript by default, and require no additional set
up. However, you should check your Web browser's features and configuration to be sure frames and
JavaScript are enabled.
NOTE:
JavaScript is not the same as Java™. Be sure that JavaScript is enabled in your Web
browser.
Getting started
9

Advertisement

Table of Contents

   Related Manuals for HP 445860-B21 - 10Gb Ethernet BL-c Switch

Comments to this Manuals

Symbols: 0
Latest comments: