Virtual Router Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

Virtual Router Configuration

To display the following form, go to the Virtual Routers Configuration form. Select a Virtual Router number
or open the Virtual Routers folder and click Add Virtual Router.
The following table describes the Virtual Router Configuration controls:
Virtual Router Configuration controls
Table 166
Control
Virtual Router Number (1-250)
Virtual Router Identifier (1-250)
IP Address
Descriptions
Defines the virtual router number.
Defines the virtual router ID. This is used in conjunction with addr (below)
to define a virtual router on this switch. To create a pool of VRRP-enabled
routing devices which can provide redundancy to each other, each
participating VRRP device must be configured with the same virtual router:
one that shares the same vrid and addr combination.
The vrid for standard virtual routers (where the virtual router IP address is
not the same as any virtual server) can be any integer between 1 and 250.
The default value is 1.
All vrid values must be unique within the VLAN to which the virtual
router's IP interface belongs.
Defines the IP address for this virtual router using dotted decimal notation.
This is used in conjunction with the vrid (above) to configure the same
virtual router on each participating VRRP device. The default address is
0.0.0.0.
Configuring the switch
239