Rip Interfaces Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

RIP Interfaces Configuration

To display the following form, select Layer 3 > Routing Information Protocol > RIP Interfaces
(click the underlined text, not the folder).
RIP is used for configuring Routing Information Protocol parameters. This option is turned off by default.
NOTE: Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interfaces Configuration controls:
RIP Interfaces Configuration controls
Table 161
Control
Search Range
Search Options
Description
To search for a RIP interface, enter a range of interface numbers in the From and To
fields.
To focus the search for a VLAN, enter optional search parameters:
RIP Version
RIP state
Fields that have a value of "any" are ignored during the search.
Choose a search operation:
or: Search for RIP interfaces specified in the search range that meet any of the
criteria entered.
and: Search for RIP interfaces specified in the search range that meet all of the
criteria entered.
Click Search to display RIP interfaces that fit the range and meet the criteria entered.
Configuring the switch
234