Download  Print this page

Default Gateway Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

Hp 10gb ethernet bl-c switch browser-based interface reference guide.
Hide thumbs

Advertisement

Default Gateway Configuration

To display the following form, go to the Default Gateways Configuration form. Select a Default Gateway
ID, or open the Default Gateways folder and click Add Default Gateway.
Default Gateways are disabled by default.
The following table describes the Default Gateway Configuration controls:
Table 146
Default Gateway Configuration controls
Control
Default Gateway Identifier (1-4, 254)
Default Gateway IP Address
Enable/Disable Default Gateway
Enable/Disable ARP only health checks
Health Check Interval (0-60 sec)
Retries before Out of Service (1-120)
Description
Selects a default Gateway to configure.
Configures the IP address of the default IP gateway using dotted decimal
notation.
Enables or disables the gateway for use.
Enables or disables Address Resolution Protocol (ARP) health checks. This
command is disabled by default.
The switch pings the default gateway to verify that it's up. The interval
option sets the time between health checks. The range is from 0 to 60
seconds. The default is 2 seconds.
Sets the number of failed health check attempts required before declaring
this default gateway inoperative. The range is from 1 to 120 attempts.
The default is 8 attempts.
Configuring the switch
214

Advertisement

Table of Contents

   Related Manuals for HP 445860-B21 - 10Gb Ethernet BL-c Switch

   Related Content for HP 445860-B21 - 10Gb Ethernet BL-c Switch

Comments to this Manuals

Symbols: 0
Latest comments: