The following table describes the RIP Route Redistribution Configuration controls:
RIP Route Redistribution Configuration controls
Metric (1-15, 0 = none)
Route Maps Available
Out Route Map List
RIP General Configuration
To display the following form, select Layer 3 > Routing Information Protocol > General.
The following table describes the RIP Interface Configuration controls:
RIP General Configuration controls
Globally Enable RIP?
Update Period (1-120 sec)
Exports the routes of this protocol in which the metric and metric type are specified.
To remove a previous configuration and stop exporting the routes of the protocol,
enter 0 (none).
Lists the route maps that can be added to the list of OSPF static route.
Lists the route maps that are members of the RIP route.
Select a route map number in the Route Maps Available list and click Add to add
the route map to the list of RIP Redistribution routes.
Select a route map number in the Out Route Map list and click Remove to remove
the route map from the list of RIP Redistribution routes.
Globally enables or disables RIP.
Configures the time interval for sending for RIP table updates, in seconds.
The default value is 30 seconds.
Configuring the switch