Download  Print this page

Switch Image And Configuration Management Buttons - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

Hp 10gb ethernet bl-c switch browser-based interface reference guide.
Hide thumbs

Advertisement

Switch Image and Configuration Management buttons

The following table describes Switch Image and Configuration Management buttons:
Table 106
Switch Image and Configuration Management buttons
Button
Get Image
Put Image
Get Config
Put Config
Put TS Dump
Put Dump
Clear Flash Dump
Submit
REBOOT!
NOTE:
If the TFTP server is running SunOS or the Solaris operating system, the specified Put Config
file must exist prior to executing the Put Config command and must be writable (set with proper
permission, and not locked by any application). The contents of the specified file will be replaced
with the current configuration data.
Description
Starts download of the software image file indicated in TFTP Image Filename field from the
specified TFTP server.
Starts upload of the software image file indicated in TFTP Image Filename field from the
specified TFTP server.
Downloads a previously saved switch Configuration Block file indicated in Configuration
Filename from the specified the TFTP server.
The active configuration will be replaced with the commands found in the downloaded
configuration file. The file can contain a full switch configuration or a partial switch
configuration.
The new configuration is not activated until the apply command is used. If the apply
command is found in the configuration script file loaded using this command, the apply
action is performed automatically.
Uploads the switch's active configuration to the script configuration file specified in
Configuration Filename. The file is placed on the TFTP server.
Uploads the TS (tech support) dump file to the TFTP server specified in TSTP TS Dump
Filename.
Uploads the core (PANIC) dump file to the TFTP server specified in Core Dump Filename.
Deletes the core dump in flash memory.
When selected, the form is sent to the switch. Any configuration changes are placed in the
"pending" state and do not take effect until the toolbar Apply command is given.
Reboots the switch.
Configuring the switch
164

Advertisement

Table of Contents

   Related Manuals for HP 445860-B21 - 10Gb Ethernet BL-c Switch

Comments to this Manuals

Symbols: 0
Latest comments: