HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual page 163

Table 105 Switch Image and Configuration Management controls
Control
Next Boot Image Selection
Active Configuration Block
Next Boot Configuration Block Selection
Next CLI Boot Mode Selection
FTP/TFTP Settings
Hostname or IP Address of TFTP server
Username for FTP Server or Blank for TFTP
Server
Password for FTP Server
Port for Transfer
Image Settings
Image for Transfer
Image Filename (on server)
Image Filename (on HTTP Client)
Config/Dump Settings
Configuration Filename
TS Dump Filename
Flash Dump Filename
Status of Previous Transfer
Description
Selects which software image (image1 or image2) you want to run in
switch memory for the next reboot.
Displays the Configuration Block file that is currently running (active or
backup).
Selects the Configuration Block file (active or backup) that will run after
the next reboot.
Selects the type of command-line interface (CLI) used after the next
reboot.
Enter the host name or IP address of the TFPT server from which you
will download software.
Enter the user name, if you are using a FTP server.
Enter the password for FTP server.
Select the port type to use for the file transfer (management port or
data port).
Selects a software image to replace with the downloaded software.
Enter the name of the file on a TFTP server that contains the software
image you want to download.
Enter the name of the file on an HTTP Client that contains the software
image you want to download.
Selects the file name and location of the Configuration Block file to be
downloaded.
Selects the filename for the TS (tech support) dump that you want to
upload to the TFTP server.
Selects the filename for the core (PANIC) dump that you want to
upload to the TFTP server.
Displays the status of the previous software download attempt.
Configuring the switch
163