HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual page 146

The following table describes the Switch Management Processor Configuration (basic) controls:
Switch Management Processor Configuration (Basic) controls
Table 96
Control
Switch IP Address
Switch IP Subnet Mask
Enable/Disable BOOTP for IP
Management
Enable/Disable DHCP for
Management Interface
Enable/Disable Console output of
syslog messages
Enable/Disable Host Name
Syslog Host IP Address
Transfer Port of Syslog Host
Severity of Syslog Host
Facility of Syslog Host
Second Syslog Host IP Address
Transfer Port of Second Syslog Host
Severity of Second Syslog Host
Facility of Second Syslog Host
Current Date
Current Time
Login Notice
Banner
Description
Configures the IP address of the switch interface using dotted decimal
notation.
Configures the IP subnet address mask for the interface using dotted
decimal notation.
Enables or disables the use of BOOTP. If you enable BOOTP, the switch will
query its BOOTP server for all of the switch IP parameters. This command is
enabled by default.
Enables or disables Dynamic Host Control Protocol for setting the
management IP address.
Enables or disables delivering syslog messages to the console. When
necessary, disabling console ensures the switch is not affected by syslog
messages. It is enabled by default.
Enables or disables displaying of the host name (system administrator's
name) in the Command Line Interface (CLI).
Sets the IP address of the first syslog host.
Configures the type of port used for data transfers between the switch and
the primary Syslog host.
This option sets the severity level of the first syslog host displayed. The
default is 7, which means log all the seven severity levels.
This option sets the facility level of the first syslog host displayed. The
default is 0.
Sets the IP address of the second syslog host.
Configures the type of port used for data transfers between the switch and
the secondary Syslog host.
This option sets the severity level of the second syslog host displayed. The
default is 7, which means, log all seven severity levels.
This option sets the facility level of the second syslog host displayed. The
default is 0.
Configures the system date.
Configures the system time using a 24-hour clock format.
Displays login notice immediately before the "Enter password:" prompt in
the Command Line Interface (CLI). This notice can contain up to 1024
characters and new lines.
Configures a login banner of up to 80 characters. When a user or
administrator logs into the switch Command Line Interface (CLI), the login
banner is displayed.
It is also displayed as part of the output from the /info/sys/gen
command.
Configuring the switch
146