Loading The Netware Drivers At Server Bootup - HP D7171A - NetServer - LPr Installation Manual

18
Select Save parameters and load driver.
19
Respond No to the prompt Do you want to select an additional
Disk driver?
20
Press Esc until you return to the Installation Options menu. If
necessary, modify the load command line in the startup.ncf file
so that the proper path to the driver and all appropriate
command line options are specified. See Loading the NetWare
Drivers at Server Bootup on page 4-17. Otherwise, exit the
nwconfig program.
21
Install the Novell NetWare Support Pack 1 or higher.

Loading the NetWare Drivers at Server Bootup

To automatically load the netr4m.ham driver at server bootup, the
startup.ncf file (usually located in your server's startup directory)
must contain a load command line that specifies the location of the
driver and any appropriate command line options. For additional
information on the startup.ncf file, refer to your NetWare
documentation.
The correct syntax to load the driver is
load [pathname]netr4m.ham [options]
For example, the command line to load the driver from the
c:\nwserver directory, with the verbose= option on is
load c:\nwserver\netr4m.ham verbose=y
Command line options are not case sensitive. Placing commas
between command line options is optional. To modify the
startup.ncf file, follow these steps:
Note:
You can also use your DOS text editor to modify the
startup.ncf file.
1
Do one of the following:
– In NetWare 4.20, type load install at the NetWare prompt
and press Enter.
– In NetWare 5.1 type load nwconfig at the NetWare prompt
and press Enter.
Installing the Device Drivers
4-17