Installing The Drivers When Netware 5.1 Is Already Installed - HP D7171A - NetServer - LPr Installation Manual

Note: If the embedded driver has not been installed,
install it before installing the HP NetRAID-4M
drivers. Refer to your Hewlett-Packard server
documentation for further information.
5
Insert the HP NetRAID-4M driver diskette for NetWare V5.1
(NOS Driver - NetWare 5/5.1 <NetServer Name>) into your
disk drive and press the Insert key.
6
An explanatory screen appears. Press Enter to have the system
scan the diskette for the HP NetRAID-4M driver.
7
Select netr4m.HAM Hewlett-Packard Array Controller and
press Enter. This will bring you to the HP NetRAID-4M
Parameters screen.
8
Select Return to driver list to accept the default slot number
and press Enter.
9
Press Esc.
10
Select Return to driver summary, and press Enter.
11
If desired, select the I2OPCI.NLM driver and install it. You can
enter the slot number as suggested in the Slot Number Help
screen.
12
Press Esc.
13
To continue the NetWare installation, select Continue and
press Enter.
14
When the NetWare installation completes, install the Novell
NetWare Support Pack 1 or higher.

Installing the Drivers when NetWare 5.1 is Already Installed

To update or install the netr4m.ham driver when NetWare 5.1 is
already installed, follow the instructions in this section. Before you
begin, however, make a backup copy of the driver.
1
At the NetWare console prompt, type load nwconfig.
2
Select Driver Options and press Enter.
Installing the Device Drivers
4-15