Aborting Controller Startup; Configuring The Hp Netraid-4M Remote Agent For Netware - HP D7171A - NetServer - LPr Installation Manual

Hewlett-Packard NetRAID-4M Controller Installation Guide
The default is Normal. Maintenance mode allows the system to
be started in cases where you are experiencing HP NetRAID-
4M problems and cannot otherwise boot your system.
Clear NVRAM— When Enabled, this option clears the
HP NetRAID-4M NVRAM (nonvolatile DIMM) of its contents.
The default is Disabled.
Caution:
Clearing the NVRAM can have serious
!
consequences! Loss of data occurs if the NVRAM is
cleared when it contains valid data which has not been
written to disk. Only an authorized individual should
clear the NVRAM.

Aborting Controller Startup

If the controller is not functioning properly and cannot start, you can
by-pass the controller startup process without having to wait several
minutes for the controller to time-out. To bypass the controller
startup process, press <Ctrl>-<K> when you see the following
prompt on the console:
Press <Ctrl><K> to abort waiting for
controller to start
Note that if the controller is functioning properly, the <Ctrl>-<K>
key is disabled after the first two minutes at boot-time.
Configuring the HP NetRAID-4M Remote Agent
for NetWare
The NetWare HP NetRAID-4M remote agent allows you to disable
remote access, permit read-only access and require a remote user to
supply a password before allowing a remote connection. You can
configure the HP NetRAID-4M remote agent by editing the
file. To edit the file, type load edit hpnagent.ini at the
hpnagent.nlm
NetWare console prompt. Make the desired changes to the .ini file
and exit the editor (see Access and Communications on page C-6 for
settings). After the file has been edited, restart the hpnagent.nlm
application so that the software recognizes that configuration
changes have occurred. To do this, type unload hpnagent
followed by load hpnagent at the console prompts.
C-4