Starting The Scsiselect Utility; Using Scsiselect Menus - HP D7171A - NetServer - LPr Installation Manual

Hewlett-Packard NetRAID-4M Controller Installation Guide
Initiate Sync Negotiation
Maximum Transfer Rate
Enable Disconnection
Initiate Wide Negotiation
1
This option is used to control the cache on the drive, not the HP NetRAID-4M. We
recommend that the drive write cache remain disabled for maximum data protection.
2
This option is available only if Wide SCSI is supported on the attached drives.
If you want to view and/or change the current settings, see Starting
the SCSISelect Utility on page A-2. For detailed descriptions of each
setting, see Using the Controller Configuration Utility on page A-3.

Starting the SCSISelect Utility

To start SCSISelect
1
Press Ctrl-A when the following prompt appears when you
turn on or reboot your server:
Press <Ctrl><A> for Configuration Utility!
2
If multiple controllers are installed, select the controller you
want to configure and press Enter.
3
Select SCSISelect Utility from the menu.
The menu that appears displays the options Controller
Configuration and SCSI Configuration.

Using SCSISelect Menus

To select a SCSISelect menu option, move the cursor to the option
with the and keys, then press Enter. In some cases, selecting an
option displays another menu. You can return to the previous menu
at any time by pressing Esc.
To restore the original SCSISelect default values, press F6 from the
Configure/View Host Adapter Settings screen.
To toggle the display between color and monochrome modes, press
F5 from the main SCSISelect screen (note, however, that this feature
does not work on some monitors).
A-2
Yes
160 MBytes/sec
Yes
2
Yes