Netware 5.1 Environment; Installing The Drivers During A Fresh Install Of Netware 5.1 - HP D7171A - NetServer - LPr Installation Manual

Hewlett-Packard NetRAID-4M Controller Installation Guide
Caution:
Novell recommends installing the Support
!
Pack on your server from a client. If installing the
Support Pack from a CD, mount the CD as a NetWare
volume and then install the software.

NetWare 5.1 Environment

This section explains how to install the driver, netr4m.ham , for
Novell NetWare 5.1. If you are performing a first time NetWare
installation, see Installing the Drivers During a Fresh Install of NetWare
5.1 on page 4-14. If NetWare is already installed in your system, see
Installing the Drivers when NetWare 5.1 is Already Installed on
page 4-15. You need to load the netr4m.ham driver for every
HP NetRAID-4M controller installed in your system.
Note:
We recommend that you install your NetWare
operating system on a container to take advantage of the
redundancy and performance features of the container.

Installing the Drivers During a Fresh Install of NetWare 5.1

Follow these instructions only if you are installing NetWare 5.1 for
the first time. If you want NetWare to reside on a container, first
create a boot container (see Appendix B, Using the BIOS Container
Configuration Utility), then install the drivers and software on that
container.
1
Begin installing NetWare 5.1 on your server as instructed in
your NetWare documentation.
2
When the Detected Device Types screen appears, select
Modify and press Enter. Then select Storage Adapters and
press Enter.
3
Select I2OPCI.NLM and press Delete.
If you choose to install I2OPCI, you can add the driver back
after the netr4m.ham driver is inserted.
4
Check that the proper driver for any embedded SCSI
controllers is installed.
4-14