Hewlett-Packard NetRAID-4M Controller Installation Guide
Note:
If the battery enable jumper is not connected or
if the battery is disconnected from the two jumper
pins, the controller will not pass the Power-On Self-
Test (POST), and data is not accessible.
4
Insert the HP NetRAID-4M in the expansion slot as shown in
Figure 2-3. Press down firmly so that the bus contacts are
securely seated in the slot. Secure the bracket with the screw
you removed in the previous step.
Note:
The HP NetRAID-4M should only be installed in
a full-length PCI slot that includes a card support
guide as shown in Figure 2-3. Due to the mass of the
HP NetRAID-4M, this support is necessary to ensure
reliable operation. Also, when inserting the
HP NetRAID-4M be sure the bracket is aligned with
the slot.
2-4