Installing The Drivers When Windows 2000 Is Already Installed; Installing The Drivers When Windows 2000 Is - HP D7171A - NetServer - LPr Installation Manual

8
You will be shown a list with one item on it; press Enter to
select the drivers — HP NetRAID-4M RAID CONTROLLER.
9
If you have no other drivers that you need to install, press
Enter to continue with the installation. Follow the instructions
onscreen and in the Windows 2000 documentation to complete
the installation.
10
When the installation completes, the Found New Hardware
wizard automatically runs. Ensure that the NOS Drivers -
Windows 2000 <NetServer Name> Disk #1 is inserted in the
floppy drive, and then make the necessary selection to install
the Windows 2000 drivers from the diskette.
11
To load the Windows 2000 drivers, remove the HP NetRAID-
4M RAID CONTROLLER Windows 2000 Drivers diskette from
the floppy drive and reboot the system.
Installing the Drivers When Windows 2000 is Already
Installed
To install the drivers when Windows 2000 is already installed on
your system, follow these steps:
1
Ensure that the HP NetRAID-4M controller is installed in your
system, then reboot your system so that the system can
recognize the controller.
When the system is rebooted and the controller recognized,
Windows 2000 automatically launches the Found New
Hardware wizard, which you use to install the Windows 2000
drivers for the HP NetRAID-4M controller.
2
The Found New Hardware wizard displays a Files Needed
dialog box, which prompts for the location on the A drive for
the driver files for the HP NetRAID-4M controller. Insert the
diskette labeled NOS Drivers - Windows 2000 <NetServer
Name> Disk #1 in the A drive and click OK.
The system then installs the driver.
3
When the driver finishes installing, click Finish to exit the
Found New Hardware wizard.
4
At the message Do you want to restart the computer now?,
remove the diskette from the floppy drive and click Yes to
reboot the system.
Installing the Device Drivers
4-9