Installing The Drivers When Upgrading To Windows 2000 - HP D7171A - NetServer - LPr Installation Manual

Hewlett-Packard NetRAID-4M Controller Installation Guide

Installing the Drivers When Upgrading to Windows 2000

To install the HP NetRAID-4M drivers during an upgrade to
Windows 2000, follow these steps.
1
Uninstall the Controller Management Software (FAST and the
CLI). For instructions on how to perform the deinstallation, see
Uninstalling the Controller Management Software on page 5-3.
2
Insert the diskette labeled NOS Drivers - Windows 2000
<NetServer Name> Disk #1 into the A drive and do not
remove it from the drive. The diskette contains the following:
– A setup script, w2ksetup.bat,that prepares your system
for the upgrade to Windows 2000.
– The HP NetRAID-4M driver for Windows 2000.
3
From the command prompt, change your working directory to
the A drive, and execute the following command:
A:\netraid4m\w2ksetup.bat
The w2ksetup.bat script prepares your system for the
upgrade to the new HP NetRAID-4M driver for Windows
2000.
4-6