Hewlett-Packard NetRAID-4M Controller Installation Guide
Communications
The communications section provides switches that control how
communication will be configured. The communication section will
contain the following switches:
Use_IP — if this switch is set to TRUE then the HP NetRAID-
4M Remote Agent will attempt to use IP as a communications
protocol.
IP_PORT — this switch will specify, in decimal, the IP port
that will be used for communications. This may be helpful to
users that are trying to access the controller through a firewall.
The IP_PORT is specified as a four-octet address, for example,
128.10.2.30.
Use_IPX — if this switch is set to TRUE then the HP NetRAID-
4M Remote Agent will attempt to use IPX as a communications
protocol.
IPX_SOCKET — this switch will specify, in decimal, the IPX
socket that will be used for communications. This may be
helpful to users that are trying to access the controller through
a firewall. The IPX_SOCKET is specified as a hexadecimal
address, for example, 4640E44D.000000000001.
Client_timeout — this switch specifies, in seconds, the amount
of time that the software will allow to expire before closing
communications with the client.
C-6