Controller Log Information; Controller Configuration Options - HP D7171A - NetServer - LPr Installation Manual

Caution: The Controller Service utility is intended to assist
!
technical support representatives in troubleshooting
controller problems; it should not be used under normal
operating conditions.
Follow these steps to access the Controller Service utility:
1
Press Ctrl-A when the following prompt appears when you
turn on or reboot your server:
Press <Ctrl><A> for Configuration Utility!
2
If multiple controllers are installed, select the controller you
wish to configure and press Enter.
3
Press Ctrl-P to start the Controller Service Utility. A two-
option menu appears.
4
Select Additional Controller Configuration to access
advanced BIOS settings or select Controller Log Information
to view detailed information on the current BIOS log and the
previous BIOS log and press Enter.

Controller Log Information

If you are experiencing system problems, your technical service
representative can access the controller log to gain detailed
information on the internal operations of the HP NetRAID-4M
during the current boot and the previous boot.

Controller Configuration Options

The following options are available in the Controller Service utility:
Force Single Container Configuration — If Enabled, this
option causes the HP NetRAID-4M to configure only the boot
container to be able to boot; any other containers are ignored.
The default is Disabled. Use this option if you encounter
problems booting the controller because of problems with
containers other than the boot container.
Boot Mode — This option sets the mode for the next boot. If
Normal, then all of the containers and files systems will be
configured (if possible) during system boot. If Maintenance,
then none of the containers or file systems will be configured.
Troubleshooting
C-3