HP D7171A - NetServer - LPr Installation Manual page 38

Hewlett-Packard NetRAID-4M Controller Installation Guide
Note:
To install Windows NT from a bootable CD, the
CD-ROM drive must be connected to another SCSI
controller or an IDE controller (not the HP NetRAID-
4M).
2
When the Windows NT CD starts to boot it will display the
following message:
Setup is inspecting your computer's hardware configuration....
Press F6 immediately.
3
A few seconds later a screen will be displayed asking you to
specify additional adapters.
4
Press S to select additional hardware.
5
A menu with several items will be displayed. Be sure that
Other is highlighted and then press Enter to load the device
drivers.
6
You will be prompted to insert a disk into drive A. Insert the
disk labeled NOS Drivers - Windows NT4.0/Windows NT 4.0
Cluster <NetServer Name> Disk #1
7
Press Enter to start the load of the drivers.
8
Select the following driver: HP NetRAID-
4M RAID CONTROLLER.
9
If you have no other drivers that you need to install, press
Enter to continue with the installation. Follow the instructions
on-screen and in the Windows NT documentation to complete
the installation.
Installing Windows NT from Diskette
1
Start your system with the Windows NT boot diskette in the
floppy drive and proceed with the Windows NT installation.
2
At the message Setup has recognized the following mass
storage devices, press S.
3
Insert the diskette labeled NOS Drivers - Windows
NT4.0/Windows NT 4.0 Cluster <NetServer Name> Disk #1
and press Enter.
4-4