Installing The Drivers During A Fresh Install Of Windows 2000; Installing The Drivers During A Fresh Install Of - HP D7171A - NetServer - LPr Installation Manual

Hewlett-Packard NetRAID-4M Controller Installation Guide
The upgrade then continues to completion.
6
After the upgrade completes, reinstall the controller
management software. For instructions on how to preform the
installation, see Installing the Controller Management Software on
page 5-2.
Installing the Drivers During a Fresh Install of Windows
2000
Follow these instructions to install the Windows 2000 drivers while
you are installing Windows 2000. Windows 2000 will be installed on
a boot container if you create a boot container with the Container
Configuration Utility. (For information on creating a boot container,
see Appendix B, Using the BIOS Container Configuration Utility.)
1
Start your system with the Windows 2000 boot CD in the
CD-ROM drive and proceed with the Windows 2000
installation.
Note:
To install Windows 2000 from a bootable CD, the
CD-ROM drive must be connected to another SCSI
controller or an IDE controller (not the HP NetRAID-
4M).
2
When the Windows 2000 CD starts to boot it will display the
following message:
Setup is inspecting your computer's hardware configuration....
Press F6 immediately.
3
A few seconds later a screen will be displayed asking you to
specify additional adapters.
4
Press S to select additional hardware.
5
A menu with several items will be displayed. Be sure that
Other is highlighted and then press Enter to load the device
drivers.
6
You will be prompted to insert a diskette into drive A. Insert
the diskette labeledNOS Drivers - Windows 2000 <NetServer
Name> Disk #1.
7
Press Enter to start the load of the drivers.
4-8