HP D7171A - NetServer - LPr Installation Manual page 59

Note: Owing to a software limitation, OpenServer's method
of statically configuring each disk into the kernel can cause
user confusion. The difficulty arises from OpenServer's
convention for naming drives. The drive_config utility
overcomes this limitation by automatically creating the
appropriate kernel entries and then rebuilding/relinking
the kernel.
The drive_config utility automatically creates device special
files in the /dev/rdsk and /dev/dsk directories. These
files are named in the c#t#d#s# (controller number, target
number, disk number, fdisk partition number) format. On a
data container, the files c0t0d0 and c0t0d0s0 point to the
first container that was created.
For more information on OpenServer disk partitioning
conventions, see the appropriate OpenServer
documentation.
h
When prompted by the idbuild utility, answer Yes to both
questions.
i
Unmount the Navigator cdrom by entering the following
command:
umount /mnt/cdrom
j
Remove the driver cdrom from the cdrom drive.
k
Reboot your system to load the hpnraid driver.
Installing the Device Drivers
4-25