HP D7171A - NetServer - LPr Installation Manual page 54

Hewlett-Packard NetRAID-4M Controller Installation Guide
./drive_config
Note:
Owing to a software limitation, OpenServer's method
of statically configuring each disk into the kernel can cause
user confusion. The difficulty arises from OpenServer's
convention for naming drives. The drive_config utility
overcomes this limitation by automatically creating the
appropriate kernel entries and then rebuilding/relinking
the kernel.
The drive_config utility automatically creates device special
files in the /dev/rdsk and /dev/dsk directories. These
files are named in the c#t#d#s# (controller number, target
number, disk number, fdisk partition number) format. On a
boot container, the files c0t0d0 and c0t0d0s0 point to the
entire disk.
For more information on OpenServer disk partitioning
conventions, see the appropriate OpenServer
documentation.
i
Answer yes to all prompts from the idbuild utility.
j
When the driver configuration completes, reboot your
system so that the operating system will recognize the
driver.
4-20