HP D7171A - NetServer - LPr Installation Manual page 118

Hewlett-Packard NetRAID-4M Controller Installation Guide
Component
PCI bus
Ultra2SCSI (LVD)
channels
Device support
Operating system support
Remote management
Recommended minimum system requirements
PCI-based, 2.1-compliant, 75 MHz Pentium or equivalent motherboard
64 MB system memory
Full-sized 3.3 or 5 V PCI slot that supports bus mastering
Physical and environmental
Dimensions
Operating temperature
Storage temperature
Humidity (operating)
Power requirements
1
If you are hot-plugging a HP NetRAID-4M controller on a NetWare 5.x system, do not use
the NCMCON.NLM utility to load or reload the device drivers, since the NetWare system's
probe routine will time out before the controller boots. Manually reload the drivers at least
60 seconds after repowering the PCI slot that contains the hot-plugged controller.
2
The actual number of controllers that will function in a system depends on the system
motherboard, the amount of system memory installed, and other PCI controllers installed
in the system. Refer to your system specifications.
E-2
Description
64-bit, 33 MHz (32-bit, 33 MHz-compatible)
1
Hot-plug PCI-ready
4 channels (4 external and 2 internal connectors).
Up to 60 SCSI devices per controller (15 per
channel)
Up to 8 RAID controllers per server
Supports RAID array as boot device
Supports board hot swapping
Windows NT 4.0 (Service Pack 6A or higher)
Windows 2000
NetWare 4.2 (Service Pack 7 or higher)
NetWare 5.0 (Service Pack 1 or higher)
NetWare 5.1 (Service Pack 1 or higher)
SCO OpenServer 5.0.5
SCO UnixWare 7.1.1
Red Hat Linux 7.0
Windows NT 4.0 (Service Pack 6A or higher),
Windows 2000
Full-sized PCI card (12.283 in. x 4.2 in.; 31.191 cm
x 10.668 cm)
0 to 40 °C
–40 to 64 °C
20 to 90%, noncondensing
5 V
2