Installing The Unix Drivers On A Data Container - HP D7171A - NetServer - LPr Installation Manual

UnixWare
Caution:
Owing to limitations in UnixWare that prevent
!
UnixWare from seeing the sub-vendor and sub-system IDs
of PCI boards, in some cases the hpnraid driver may be
mapped to the wrong device, mapped to a non-existent
device, or a driver other than the hpnraid driver may be
mapped to the board.
The correct subsystem device ID for the HP NetRAID-4M is
10C2, and the correct subsystem vendor ID is 103C.
SCO has published a workaround for this problem on their
website, www.sco.com.
We suggest that you apply this workaround when installing
the hpnraid driver on UnixWare.
a
During the installation, when prompted for additional
drivers, insert the diskette you created that contains the
SCO UnixWare 7.x Boot NetRAID-4M driver into your
system's diskette drive.
b
Continue the installation of the operating system.

Installing the UNIX Drivers on a Data Container

To install UNIX drivers to a data container, follow these steps:
1
Log on as root or become superuser.
2
Check to see if the hpnraid driver already exists on your
system, and if it does, remove it.
Linux
The Linux driver is now part of the standard open source
distribution. Obtain the Linux operating system from an open
source provider. For example, download the operating system
from an open source web site such as www.redhat.com and
follow their instructions for removing the working driver for
Installing the Device Drivers
4-21