Windows 2000 - HP D7171A - NetServer - LPr Installation Manual

Caution: During the upgrade to Windows 2000, the
!
Hewlett-Packard NetRAID-4M device drivers for
Windows NT that are currently installed on your
system are replaced with HP NetRAID-4M drivers for

Windows 2000.

If, for whatever reason, you execute the script
w2ksetup.bat but do not complete the upgrade to
Windows 2000, you must re-install the Hewlett-
Packard NetRAID-4M device drivers, because--
among other things -- w2ksetup.bat removes the
HP NetRAID-4M drivers for Windows NT from your
system.
Therefore, if you do not reinstall the HP NetRAID-4M
drivers for Windows NT, you will not be able to
manage the controller, and if the operating system is
on a boot container, the server will not boot.
To reinstall the HP NetRAID-4M drivers for Windows
NT, go to Control Panel —> SCSI Adapters. Select the
Drivers tab, then select the Hewlett-
Packard NetRAID-4M and press Add. Select Have
Disk, then when prompted, insert the diskette that
contains the HP NetRAID-4M drivers for Windows
NT.
After the original NT drivers are installed, reboot and
you will be able to manage your HP NetRAID-4M
controller.
4
Insert the Windows 2000 CD-ROM into your CD drive.
5
When the upgrade dialog box appears, select the option to
Upgrade to Windows 2000.
Follow the on-screen instructions to begin the upgrade to
Windows 2000.
A popup message is displayed, asking if you want to continue
installing an unassigned driver. Select Yes.
Installing the Device Drivers
4-7