HP D7171A - NetServer - LPr Installation Manual page 60

Hewlett-Packard NetRAID-4M Controller Installation Guide
UnixWare
Caution:
Owing to limitations in UnixWare that
!
prevent UnixWare from seeing the sub-vendor and
sub-system IDs of PCI boards, in some cases the
hpnraid driver may be mapped to the wrong device,
mapped to a non-existent device, or a driver other
than the hpnraid driver may be mapped to the board.
The correct subsystem device ID for the HP NetRAID-
4M is 10C2, and the correct subsystem vendor ID is
103C.
SCO has published a workaround for this problem on
their website, www.sco.com.
We suggest that you apply this workaround when
installing the hpnraid driver on UnixWare.
a
Place the Navigator cdrom which contains the SCO
UnixWare 7.x Non-Boot NetRAID-4M driver in the drive.
The operating system may automount the cdrom on
/mnt/cdrom. If not, do the following:
i
Create the mount point by entering the following
command:
mkdir /mnt/cdrom
ii
Mount the cdrom on /mnt/cdrom by entering a
command like the following, replacing CDROM_LUN
with the logical unit number of your cdrom device (note
that in most cases the default cdrom lun is cdrom1:
mount -F cdfs -r /dev/cdrom/CDROM_LUN /mnt/cdrom
b
Change your working directory by entering the following
command:
cd /mnt/cdrom/periph/nraidadp/unixware/driver
c
Copy the file that contains the hpnraid driver to /tmp by
entering the following command:
4-26