Performing Initial Configuration; J-Ex8200 Switch Default Configuration - Dell PowerConnect J-EX8216 Hardware Manual

CHAPTER 11

Performing Initial Configuration

J-EX8200 Switch Default Configuration

J-EX8200 Switch Default Configuration on page 143
Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 144
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 146
Each J-EX8200 switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file sets values for system parameters such as the ARP aging timer, the
system log, and file messages, while also enabling the LLDP protocol, the RSTP protocol,
IGMP snooping, and storm control.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. You can always revert to the factory default
configuration. For instructions for reverting to the factory configuration, see the Dell
PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS at
http://www.support.dell.com/manuals
This topic shows the factory default configuration file of a J-EX8200 switch:
system {
arp {
aging-timer 5
}
}
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
file interactive-commands {
interactive-commands any;
}
}
commit {
factory-settings {
.
143