Installing A Sata Or Scsi Hot-Swap Hard Disk Drive; Figure 26. Removing The Retention Device From The Hot-Swap Drive Carrier; Figure 27. Attaching A Hot-Swap Hard Disk Drive To A Drive Carrier - Intel SR2400SYS - Server Platform - 0 MB RAM User Manual

4. Remove the four screws that attach the plastic retention device or the previously installed hard
drive to the drive carrier. Two screws are at each side of the retention device or the hard drive.
If required, store the plastic retention device for future use.

Figure 26. Removing the Retention Device from the Hot-swap Drive Carrier

Installing a SATA or SCSI Hot-swap Hard Disk Drive

1. Remove the hard drive from its wrapper and place it on an antistatic surface.
2. Set any jumpers and/or switches on the drive according to the drive manufacturer's
instructions.
3. With the drive circuit-side down, position the connector end of the drive so that it is facing the
rear of the drive carrier.
4. Align the holes in the drive to the holes in the drive carrier and attach it to the carrier with the
screws that were attached to the plastic retention device.

Figure 27. Attaching a Hot-swap Hard Disk Drive to a Drive Carrier

32
A
TP00787
TP00736