Tx Matrix Host Subsystem Description; Tx Matrix Routing Engine Overview - Juniper TX MATRIX Hardware Manual

Table 5: TX-SIB LEDs (continued)
Label
TX
Related
Documentation

TX Matrix Host Subsystem Description

Related
Documentation

TX Matrix Routing Engine Overview

Copyright © 2010, Juniper Networks, Inc.
Color
—
Green
Red
TX Matrix Switch Interface Boards (TX-SIBs) Description on page 23
TX Matrix TX-SIB LEDs on the Craft Interface on page 38
Troubleshooting the TX Matrix TX-SIBs and the Switching Planes on page 216
The host subsystem provides the routing and system management functions of the
TX Matrix router. You can install one or two host subsystems on the TX Matrix router. To
operate, each host subsystem functions as a unit; the Routing Engine requires the
corresponding TX-CB, and vice versa.
NOTE: We recommend that you install two host subsystems for redundant
protection. If you install only one host subsystem, we recommend that you
install it in slot
RE0
TX Matrix Control Board (TX-CB) Description on page 32
TX Matrix Routing Engine Description on page 26
TX Matrix Host Subsystem LEDs on the Craft Interface on page 37
TX Matrix Routing Engine Description on page 26
TX Matrix RE-600 Description on page 27
TX Matrix RE-600 LEDs on page 28
TX Matrix RE-1600 Description on page 28
TX Matrix RE-1600 LEDs on page 30
TX Matrix RE-2000 Description on page 30
TX Matrix RE-2000 LEDs on page 32
Chapter 3: TX Matrix Hardware Components Overview
State Description
Off Transmit link is being reset.
On steadily Transmit link is online and functioning
normally.
On steadily Transmit link is not functioning
normally.
.
25