Juniper TX MATRIX Hardware Manual page 208

TX Matrix Hardware Guide
176
screwdriver to loosen the captive screw.) Store the dust cover in a dust-free resealable
plastic bag.
With the fiber-optic array cable extending toward the left side of the chassis (as you
3.
face the rear), align the cable connector with the T640-SIB adapter and carefully
press it into the adapter until it stops. The cable connector and adapter are keyed to
ensure proper mating.
NOTE: The optics in a fiber-optic array adapter are spring loaded, so you
must continue to apply force to a fiber-optic array cable connector or
loopback connector while securing it to a TX-SIB or T640-SIB adapter.
Partially tighten the thumbscrew and captive screw on the fiber-optic array cable
4.
connector. (Use the supplied small slotted screwdriver to tighten the captive screw.)
Alternate between the thumbscrew and captive screw until the cable connector is
secured to the adapter.
On an external management device connected to the console or auxiliary port of the
5.
T640-CIP, bring the T640-SIB online using one of the following methods:
Press and hold the ONLINE/OFFLINE
LED blinks.
OK
Issue the request chassis sib online
user@host> request chassis sib online slot 0
On an external management device connected to the console or auxiliary port of the
6.
TX-CIP, enable the TX-SIB fiber-optic array adapter receivers by issuing the
chassis sib slot start-receiver scc
LCC0 on TX-SIB-0 , issue the following command:
user@host> request chassis sib slot 0 start-receiver 0 scc
On an external management device connected to the console or auxiliary port of the
7.
T640-CIP, enable the T640-SIB fiber-optic array adapter receivers by issuing the
request chassis sib slot start-receiver
adapter on
T640-SIB-0
user@host> request chassis sib slot 0 start-receiver 0
Verify that the RX LED next to the TX-SIB adapter is steadily lit green.
8.
Verify that the LED next to the T640-SIB adapter is steadily lit green.
9. RX
If the RX LEDs next to the TX-SIB adapter and T640-SIB adapter are steadily lit green,
10.
the connection between the TX-SIB and T640-SIB is operating correctly.
If the LEDs next to the TX-SIB adapter and T640-SIB adapter are not steadily lit
RX
green, disable the TX-SIB and T640-SIB adapter receivers, disconnect the fiber-optic
array cable connector from the T640-SIB, and clean it and the T640-SIB adapter:
To disable the adapter receivers, issue the
and
request chassis sib slot stop-receiver
button on the T640-SIB faceplate until the
command. For example:
command. For example, if you are enabling adapter
command. For example, if you are enabling the
, issue the following command:
request chassis sib slot stop-receiver scc
commands on the TX Matrix router and
request
Copyright © 2010, Juniper Networks, Inc.