Installing The Tx Matrix Cable Management System; Installing The Tx Matrix Comb Panel Assembly; Figure 59: Installing The Comb Panel Assembly - Juniper TX MATRIX Hardware Manual

CHAPTER 11
Installing the TX Matrix Cable
Management System

Installing the TX Matrix Comb Panel Assembly

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Installing the TX Matrix Comb Panel Assembly on page 107
Installing the TX Matrix Cable Shelf Assembly on page 108
The comb panel assembly installs on the TX Matrix chassis. To install the comb panel
assembly (see Figure 59 on page 107):
Remove the comb panel assembly from the shipping crate.
1.
Align the four captive screws on the comb panel assembly with the mounting holes
2.
at the top of the chassis (immediately above the TX-SIB card cage).
Starting with the top two screws, partially tighten each of the four screws.
3.
Secure the comb panel assembly to the chassis by tightening each of the four screws.
4.

Figure 59: Installing the Comb Panel Assembly

TX Matrix Switch-Card Chassis (SCC) Description on page 19
TX Matrix Cable Management System Description on page 51
Installing the TX Matrix Cable Shelf Assembly on page 108
107