Table of Contents
Advertisement
TX Matrix Hardware Guide
228
Carefully push the TX-CIP straight into the chassis until it contacts the midplane.
4.
CAUTION: Be sure to slide the TX-CIP straight within the slot to avoid
damaging the connector pins on the front of the midplane.
Tighten the screws at the top and bottom of the TX-CIP faceplate.
5.
Using the labels to assist you, reattach all cables to the TX-CIP.
6.
To verify that the TX-CIP is installed correctly, plug an Ethernet cable into the
7.
ETHERNET
port on the TX-CIP. If the host module is operational, the
to indicate Ethernet activity. If you can run the CLI from a management device attached
to the TX-CIP, the TX-CIP is installed correctly.
Figure 89: Installing a TX-CIP
ACT
LED blinks
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Juniper TX MATRIX
Related Products for Juniper TX MATRIX
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - ADAPTIVE LOG EXPORTER REV1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - MANAGING VULNERABILITY ASSESSMENT V1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - INSTALLATION REV1
- Juniper SECURITY THREAT RESPONSE MANAGER - APPLICATION CONFIGURATION GUIDE REV 1
- Juniper SECURITY THREAT RESPONSE MANAGER - SOFTWARE INSTALLATION REV 1
- Juniper TePM Agent
- Juniper TCX1000
- Juniper 6rd
Need help?
Do you have a question about the TX MATRIX and is the answer not in the manual?
Questions and answers