Installing The Tx Matrix Rear Air Filter; Figure 103: Removing The Rear Air Filter Element - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide

Installing the TX Matrix Rear Air Filter

244

Figure 103: Removing the Rear Air Filter Element

To install the rear air filter (see Figure 104 on page 245):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Holding the filter by the tabs, carefully push the filter all the way into the air filter slot.
2.
Holding the filter all the way in, push it to the right side of the slot until it is held into
3.
place behind the hooks.
Move the tabs to a vertical position.
4.
Place the right edge of the honeycomb against the flange of the air filter slot.
5.
Line up the holes at the top, center, and bottom of the honeycomb with the pins in
6.
the slot and press the honeycomb into place.
Copyright © 2010, Juniper Networks, Inc.