Copyright © 2010, Juniper Networks, Inc.
LCC #0
: Links ok
lcc0-re0:
--------------------------------------------------------------------------
Fabric management SIB state:
SIB #0
plane state: S_SPARE
FPC #0
PFE #0
: Links ok
PFE #1
: Links ok
SCC
: Links ok
SIB #1
plane state: S_ACTIVE
FPC #0
PFE #0
: Links ok
PFE #1
: Links ok
SCC
: Links ok
SIB #2
plane state: S_ACTIVE
FPC #0
PFE #0
: Links ok
PFE #1
: Links ok
SCC
: Links ok
SIB #3
plane state: S_ACTIVE
FPC #0
PFE #0
: Links ok
PFE #1
: Links ok
SCC
: Links ok
SIB #4
plane state: S_ACTIVE
FPC #0
PFE #0
: Links ok
PFE #1
: Links ok
SCC
: Links ok
Verify that the state of each link is
Display the system log messages to obtain information about link failures. The
3.
file is a commonly configured destination for system log messages.
/var/log/messages
To display it, issue the
show log messages
user@host> show log messages
For more information about system log messages, see the Junos OS System Log
Messages Reference.
Your customer support representative can assist you with using the information in
the system log, along with the supplied fiber-optic array loopback connector and
adapter, to determine if you have a faulty TX-SIB, T640-SIB, or fiber-optic array cable.
CAUTION: Do not connect and disconnect a fiber-optic array cable
connector, a loopback connector, or a loopback adapter more frequently
than required to perform the procedures in this hardware guide. These
fiber-optic components are rated for a limited number of insertions
(approximately 100).
Chapter 23: Troubleshooting TX Matrix Hardware Components
.
Links ok
command:
217